Nanni Service and various tasks completed – 16 October 2021

Annual Nanni engine service by Isaac from TS Marine Ltd as per manufacturer’s recommendations.
Drain and replace gearbox oil
Drain and replace engine oil
Replace impeller
Clean out water strainer
Repaired broken bracket holding relays etc.
Replace Racor 500 series fuel filter
Replace secondary fuel filter
Replace oil filter
Engine hours: 464

We found the impeller had two vanes missing. Isaac fished them out of the heat exchange – plus a third vane.
Nice clean Racor
The steel bracket that the relay box is mounted on was broken again so Issac removed it and took it back to the workshop to re-weld with a reinforcing bracket.

Other sundry boat projects completed:

Replaced old spinnaker winches with new Harken winches. The same model as the cabin-top winches: Harken 1SP B8A.
Stern light mounting. Removed the old 3-ply mounting and reinstalled on a piece of Teflon cutting board.
Replaced the Tweaker and Gybe Preventer blocks and added a protective sheath to reduce wear on the aluminium toe-rail.
Replaced faulty Vetus bilge pump float switch with new Albin model purchased from Barton Marine.
Resolved the problem of the spinnaker halyard splice getting jammed in the masthead block by replacing splice with a Halyard Hitch knot.
Wool marker sewn into halyard to indicate when spinnaker is fully hoisted
New Plastimo Contest 101 Bulkhead Mount Compass
Installed quick release catches on the electrical switch board panel.


Comments are closed.

Website Powered by WordPress.com.

Up ↑

%d bloggers like this: